Title: pipe dream:- pylon racer(VERY FAST) Post by: aeronut94 on May 04, 2009, 10:20:18 AM hi,
i am venkatesh.this is a plane i designed myself and built it just after my exams. MATERIALS USED:- WING:- 4MM LAMINATED FOAM FUSE:- PVC ELECTRICAL CONDUIT PIPE. TAIL PLANE:- 3MM CORO CONROL SURFACES:-3MM CORO(ELEVATOR,AILERON). SPECS:- WINGSPAN:- 75CM(2FT15CM) FUSE LENGTH:-60CM(2FT) RCFORALL 9GM SERVOS:-2NOS ASTRO BRUSH LESS IN RUNNER MOTOR 4200KILOWATT/VOLT.(MODEL NO:-803V) RCFORALL 40AMP BL SPEED CONTROLLER RCFORALL 1800MAH/11.1V TOTAL WEIGHT:-500GMS. SPEED:- NOT YET MEASURED BUT VERY FAST. HERE ARE SOME PICS Title: Re: pipe dream:- pylon racer(VERY FAST) Post by: aeronut94 on May 04, 2009, 10:28:03 AM HERE IS ANOTHER PIC :-
BTW this plane you will see is made of combinations of various building materials like coro,foam,pvc pipe etc.it is because i used a lot of waste stuff lying around ;D Title: Re: pipe dream:- pylon racer(VERY FAST) Post by: sahilkit on May 04, 2009, 10:32:05 AM hi aeronut
nice plane,when are you planing to maiden it? btw the radio in the first two pictures is a JR 8 channel radio right ? and in the third picture the RX is a futaba R114F that is what i could make out from the picture ??? if my observation is right your receiver will not work with JR transmitter ! sahil Title: Re: pipe dream:- pylon racer(VERY FAST) Post by: aeronut94 on May 04, 2009, 10:36:55 AM hi sahilkit,
i have already maidened it and it flies very fast. i put the jr just to add to the baground ;D. i also have an futaba 6exap . ;) Title: Re: pipe dream:- pylon racer(VERY FAST) Post by: sahilkit on May 04, 2009, 10:51:46 AM :-X ;D
|