oops, forgot that is a KK Board, then no way other than removing cables from connectors and joint.

In KK2, BEC connected to M1 only is used to power the Flight controller and receiver - so connecting all BEC to KK2 is not a solution.

you can just short +ve rail of M2 to M8 to +ve of M1- and then the it will work

Another way if you have spare servo connection leads -

Just connect any non used motor terminal in your KK to Battery terminal in your receiver .

Hah !! Finally I hope it will be solved by this simple trick with out further soldering or cutting or buying more parts 

Parichya, I currently don't have my KK2 board in hand, can you upload a clear image of back side of your board (Preferably in Photobucket.com or in my mail)

Will KK2.0 back side do ?

Also, if i connect a port of unused Motor terminal to Rx , It will take up one of my channel , so im left with only one Ch more ....

is that right or you're trying to say something else ?

there is a separate channel or 3 pin connector for connecting receiver battery (bind cable also connected here) - this is none of any 6 control channels - you have to connect the extra power to here .

But for doing this safely, you have to cut or isolate signal lead of the extra connector.

yes there is an extra binding port.

what do I have to cut now ?

Akhil ?

connect a receiver cable from any one of M5 to M8 to the binding port and check if it is working with out reboot of KK

Nope, Rx went into Binding mode

then you might need to cut just the signal wire in that connector.

BUT YES !!! it works !!!

I put all the servos on one Cable and the 6th port to power from M5

No more reboots

but now I dont have any free port for Auto-Level

Solution for that ?

cut off the signal wire on your receiver cable, and connect it to bind port - so you can use all your 6 channels. also your servos will work.

cut off which wire ?

the white (or yellow) - the one that is farthest from Black

OK .. So i cut off the white wire and connect it to binding port and it will work ?

yeah it will.....

ok doing it . Fingers crossed. XD

IT WORKED !!!

OOLAAAALAAAAA

THANKS A LOT !!

one small thing more, how Do i enable the Self Level in my quad ?

You need to go to the Mode Settings menu in the kk 2.1 menus. There is a self level option that can be set to:
1. Aux – AUX channel controls the self-levelling function. You will need to connect one free channel (that corresponds to a 2 position switch) to the bottom most connector on the left side pins of the kk. It will then control self level. It is better than the stick option below since you can turn it on and off during flight. You can check if you have done it correctly in the receiver test menu (under AUX).
2. Stick – Turn on Self-levelling by holding the aileron to the right when arming or disarming.

so if i choose stick then I dont need to use a cable to connect the board and the Rx ?

No. I don't think you will have to in that case

alright. thanks will let you know how it goes

sooraj check your mail btw..