got a turnigy AE- 65A ESC installed it on  the plane today. along with g32  motor. and nanoteh 2250 3s.

when initially set. it did not power up the receiver at all, tried and many times and then checked it with a spare Rx pack. the BEC did  not work.

after a few tries it did start powering up the Rx and was no issue there.. then started a different issue, without prop when i ran the motor as soon as i reached full throttle the power to Rx got cut off... ran it for 1 mins at around 90% throttle

now added a prop. MA14X6 .. same problem .. at full throttle the Rx switches off. running at 90%for the next 3 mins. now the batt voltage is around 10.5V.. but now the Rx switches off at 50% throttle.

any programming fault..?? or any help on how i can solve this...?? (i am worst than useless  when it comes to electric setup .)

Can you confirm its your receiver switching off not just your motor cutting off (as in thermal cutoff/ low voltage cutoff). Have you tried it with a different receiver?

yes... its the receiver switching off....

tried with different receivers all same result...

uploading the problem ESC

1> i show the ESC so that its the same i am talking about
2> i hook up a Rx battery pack showing that the reciever is ok with the Tx on.
3> i then connect the ESC to the Rx and connect the battery.
4> the Rx does not power up
5> i disconnect the ESC from the Rx and connect a multimeter
6> multimeter shows V reading at only 2V and is not sufficient to power up the Rx.

the issue has been solved... seems that i have received a faulty item.

and hobby king has refunded me the 31$ for the same.

ISSUE RESOLVED... ITEM FAULTY.

it is just normal fet problem, good that you get your amount refunded , you can fix this problem by replacing fet ,have you send the item to hk ? or you have that with you

i have it with me...!! using it as a ESC(opto) and a Rx pack for servos

ok this can be done for sure ,enjoy