Title: kk 5.5 motor spinning problem Post by: Darshan for multirotors on May 16, 2015, 06:05:24 PM i just got my new kk 5.5 blackboard and flashed it with x copter firmware for my quad
now when i power it up and arm it, only one motor spins and that too at max throttle i experienced this with my previous multiwii board too the board is compensating for any shakes or when i tilt the copter everything is working fine and i have callibrated all escs.. any idea why this is happening?? Title: Re: kk 5.5 motor spinning problem Post by: Darshan for multirotors on May 16, 2015, 10:12:34 PM When I flash it with some other x.copter firmware ..The motor starts normally at 20%throttle. .but still I am not able to figure out 2 y the others are not spinning :headscratch:
Title: Re: Post by: sooraj.palakkad on May 16, 2015, 10:13:01 PM Which firmware you used ?.
I recommend the minsoo kim firmware..only that worked for me, please refer to my earlier thread on kk5.5 for the exact firmware version number. Title: Re: kk 5.5 motor spinning problem Post by: Darshan for multirotors on May 16, 2015, 10:26:55 PM Yes I used the exact same one this time and the above is happening
Title: Re: Post by: sooraj.palakkad on May 16, 2015, 10:27:36 PM Quad or Tri ?
Title: Re: kk 5.5 motor spinning problem Post by: Darshan for multirotors on May 16, 2015, 10:28:06 PM Quad
Title: Re: kk 5.5 motor spinning problem Post by: Darshan for multirotors on May 17, 2015, 08:39:09 AM Updated firmware to X COPTER V 2.9 Xx control KR by minsoo kin niw the one motor starts spinning at 15%throttle.. but still only one motor is working ???
Title: Re: Post by: sooraj.palakkad on May 17, 2015, 09:42:32 AM What happens if you increase throttle ?
Title: Re: kk 5.5 motor spinning problem Post by: Darshan for multirotors on May 17, 2015, 09:43:33 AM The speed of the spinning motor increases but still non of the motors spin
|