Hello!
was searching the forum and couldn't find any set-up for checking thrust. so decided to build one..
Materials:
Aluminium 'U' Channel - Used in shelves as guide-ways for glasses- found in Plywood and Glass shops
6 mm Plywood
'L' clamp - 2 Nos.
Nuts and Bolts
Cut 2 equal lengths of Aluminium 'U' Channel.
Cut 2 No. right angle triangle using 6 mm Plywood.
Leave out a 1 inch x 1 inch square at the bottom of the ply wood, Drill holes to attach the Aluminium channel to the ply wood.
Mark the centre of the 1 inch square and drill a hole of suitable size this will be the pivot point of the meter.