Greetings Folks...
I just make a small
foam cutter to cut a
foam and
thermocol. its a smaller size one. I'm using
15A Nichrome Wire. The input power is
12v and 1A power. It cuts foam very well. but I'm making this cutter with Cardboard. When I cut foam, I need to
increase the amps compared to thermocol. so The cardboard also
burnt quite. I hope I will make a
foam cutter with wood. the making video link below...
please give me a valuable suggestions and comments about Foam Cutter.
link:
some pics below
Print
