I have damaged my new 2200kv motor while reversing the shaft.  so i need burned or damaged 2200kv motor head.

can a Emax 2822 shaft fits yours. i have one lying biting dust.

if it's a d2826/6 2200kv motor, you'll require a 3.1 mm shaft.. the 2822 motor has a 3mm shaft

Thanks ashok :-) yea i can try emax motor head ill drill 1mm gap. And ill use stock 3.1mm shaft.

Dear Nithin, what have you spoilt in the new motor?..... Picture please.

these are very precise equipment and any drilling etc will not give good results.

regds
Saurabh

Or i have a hobbyking donkey motor with 4mm shaft. not working.

@saurabh sir: i wanted to reverse the shaft for my easystar 2 so i removed c clip and tried to remove the shaft from hammer but no use it was fitted too hard in the bell top, next day i took the motor to local lathe shop they tried to remove from Hydraulic press and it came out. but my bad luck while pressing in Hydraulic, the center point were the shaft will come out its slightly bent inside while pressing from the top. now shaft is sitting slightly cross 

@ashok: 4mm is too big i guess