This is a 52" twin hull RC catamaran . Built with 3mm plywood. I used fevicol as a glue. But latter switch to araldite. Below are some build logs..

Sent from my Redmi Note 4 using Tapatalk

Great going Chris  .  Subscribed

very nice.

how did you cut ? by hand or power fretsaw

52" is huge .   will be impressive when finished

I used jigsaw to cut the plywood

Sent from my Redmi Note 4 using Tapatalk

I have almost completed 90℅ of the hull.   Some more pics

Sent from my Redmi Note 4 using Tapatalk

More pic

Sent from my Redmi Note 4 using Tapatalk

No clamps. So I took anything I could. To put on some weight

Sent from my Redmi Note 4 using Tapatalk

@desachristopher,

Must be far more difficult using ply as compared to balsa.
Hope you are going to:
1. Have a thin fibreglass and epoxy finish, plus spray painted colours
2. A roaring nitro engine to make this cat really fly
3. Set an Indian speed record for boats
Looking forward to completion...
Regards

Thankx

Diy rudder

Sent from my Redmi Note 4 using Tapatalk

Looking really nice

What do you expect the total weight to be?
What size prop are you intending on using??

👍

looking really good. subscribed
Shreekant

Paint work started

Sent from my Redmi Note 4 using Tapatalk

Amazing work

Amazing Work Chris, Wish I could see it in real, 52" thats huge. BTW That Black stone (Grinding) reminded me of Goan Fish curry that my mom prepares. You found out a new use of that stone.....

nice work buddy ...

the grinding stone was Idle, so I made a good use of it.

@desachristopher,
Lovely primer preparation.
Look forward to outstanding finish!
Regards

Mr. Iyer. tomorrow I'll be painting, hope it comes good.

Quote from: desachristopher on June 20, 2017, 07:32:35 PM
Mr. Iyer. tomorrow I'll be painting, hope it comes good.

Hope you have a good spray gun. Or that you are using spray cans.
This boat deserves better than a brush job...


Edit
And you never told us about that high powered nitro engine...

I have a brushless set ready, thinking of going for a petrol engine. like brush cutters. hope I get one in local market/shops

Red n white

Sent from my Redmi Note 4 using Tapatalk

Hardware painted

Sent from my Redmi Note 4 using Tapatalk

Nice built!  Have you used epoxy fiber glass over the ply?