Scratch built Pusher - Build log

Started by docnayeem, May 29, 2014, 05:56:03 PM

Previous topic - Next topic

0 Members and 10 Guests are viewing this topic.

docnayeem

A similar aircraft
Build material
HD EPS foam
Bio- foam
Pine Sticks

sanjayrai55


docnayeem


docnayeem

Getting the Profile

docnayeem

Reenforcement with Pine sticks

docnayeem

Sandwiched in other foam block to get the bulk of fuselage ....
Its going to be a sea plane lile mermaid so needs a large surface area

docnayeem

Getting into shape

docnayeem

Thanks a lot Sanjay sir ...
Comments and suggestions ... Are welcome

docnayeem

Planning for a wing span of 30 in and mean cord of 6 in ... So got to limit the weight to aroung 500 gms  for good flying characteristics   ... Going to be a rope walk

sanjayrai55

I think you'll have to go lighter at that size

docnayeem

You mean below 500 gms  ?

docnayeem

Tail assembly and cavities for battery and receiver carved

docnayeem

Tail assembly in place

docnayeem

Weight 120gms so far ...

sanjayrai55


docnayeem

Planning for a KFm 1 or 2 aerofoil as per weight consideration

docnayeem

Thanks Sanjay sir

topalle

Seaplane? Wow!
Have you tested it on water?
Amateur photographer ... DIY enthusiast ... Scratch Builder... Student-Innovator

rcrcnitesh

keep it on very good looking till now
Maker | Aeromodeller | Teenager

docnayeem

Thanks nitesh .... Hope it will get better :)

docnayeem

KMf 2  aerofoil with 8 mm  biofoam and pine stick as reinforcement glued and fastened with masking tape

docnayeem

Assembled just to have a preview ... ;)

docnayeem

Wing in place and the motor mount made in Foam board

docnayeem


utkarshg13

Very nice sir. How was the maiden?
"If you were born with wings, do every thing you could, for flying."

sauank

sir
what is the motor,esc,prop configuration of the pusher..????
syma 9053 heli , sin-xiang 3.5 channel volitation  ,6-axis udi ufo quad, x-drone with camera.

docnayeem

Maiden was OK  ... Was a bit nose heavy ....I have to change the thrust line angle ...

docnayeem

Config : 2000 kV 30 amp 3 cell 2100 prop 6*4

ramarao

210 fpv racing quad
q100 quadcopter
1000mm DW rainbow wing
sylphid rc plane
avispad
-Twin Boom Pusher plane
FT F22 Raptor
skysurfer
Cub -j3 piper

docnayeem

Will surely put up after the required modifications