great sir i was going to ask the same question.let the radio come and we will do some testing , i have to read it out its basic first, like sub trim and all.as that will be my first radio, but i am very aware about electronics.

i am 100 % sure that the same can be done...
i asume this because when i had a tx with manual trim, and just to check how it work. i opened the entire stick mechanism and notice that the stick moves the center shaft of pot and trim moves the rest of the pot. and the trim is hot melted plastic parts inside the stick mechanism. you just have to unwind the screw of pot if used and rotate the pot slightly in opposite direction. while doing this i suggest to do this when tx is switched on and the display menu is visible.
Best of Luck
Sandeep

actually sir , same i was thinking ,will receive the radio tommarow and this will be the first work.

Shippment made. tracking sent though PM

Hi Vineet,

It seems like your inbox is full. I am not able to PM you. Any how, answer to your question (Connecting Turnigy 9x to sim without using any USB cable) is to simply follow the steps from the following link.

http://www.hobbyking.com/hobbycity/forum/forum_posts.asp?TID=1428

Infact, instead of using a usb cable, you connect the audio cable to your mic jack. Its that simple.

Regards,

Sameer.