Print Page - Cannot fly my 250 because Naze32 doesn't detect Rx signals

Title: Cannot fly my 250 because Naze32 doesn't detect Rx signals
Post by: Cycloned on March 06, 2016, 03:13:59 PM

Have tried everything to no avail. I'm using a FS CT6B and it works fine with my F450 running APM. My board and Rx are being powered correctly and I can even move my motors through CleanFlight.

The only signal that is detected is Auxiliary 1 (CH 5). Nothing else is detected.

What do I do?

Title: Re: Cannot fly my 250 because Naze32 doesn't detect Rx signals
Post by: SK1701 on March 06, 2016, 03:39:15 PM

Have you selected rx_parallel_pwm in the configuration tab?

Title: Re: Cannot fly my 250 because Naze32 doesn't detect Rx signals
Post by: Cycloned on March 06, 2016, 04:26:52 PM

Yup.

Title: Re: Cannot fly my 250 because Naze32 doesn't detect Rx signals
Post by: Cycloned on March 06, 2016, 10:57:27 PM

Found the problem, the channels are getting shorted. I checked with my DMM without connecting the receiver and the channels are not bridged. However whenever I connect the receiver to the Naze32 the DMM shows that the first 3 channels are bridged.

Why is this happening and how do I stop it?

Title: Re: Cannot fly my 250 because Naze32 doesn't detect Rx signals
Post by: nite on March 07, 2016, 01:13:10 PM

using rev.5 or rev6 ?

Title: Re: Cannot fly my 250 because Naze32 doesn't detect Rx signals
Post by: Cycloned on March 08, 2016, 11:10:37 PM

Quote from: nite on March 07, 2016, 01:13:10 PM
using rev.5 or rev6 ?

Rev 5.

RC India

RC Models => Multirotors => Topic started by: Cycloned on March 06, 2016, 03:13:59 PM