hey guys,
today i got very strenge problem.
i went to fly today...did abt 5-6 shorties...everything normal...
thn i tried to setup fail safe...
what i did:-
turned on my 9cap...thn turned on my rx 148dp...chked all controls...everything worked..went to failsafe...set it up..
thn turned off my tx to chk fail safe...model went in failsafe mode...everything was good....thn again turned on my tx...
chekd all controls...working fine....
after that i reset my rx (turned off and thn on it while tx is on) and thn i turn off my tx it didnt go in to fail safe mode...i tried this 3-4 times
so every first time it goes in fail safe mode but when reset the rx it doesnt go in failsafe mode....
(everything was working very very fine last week..with the same tx and rx..same model same servos...)
i hope u get it all....
plz help me....