This deal can also be sold separately. Single working v911 heli with tx, 3 batteries, charger and spare main and tail blade for 7k including Shipping, in original box.

See post number#0,1 and 15 for pics.
Thanks

@romanxdsouza,

Care: 2 of the videos are private!

Using empty blister pack for glue is a great idea.
What glue? CA?
I tried a syringe with CA, but it often squirts.
And clogs very soon.

Super ! thanks for sharing this wonderful step by step building. Bravo! 

Next remove the paper tapes.and then use a fresh new blade to get good cuts and cut the rudder off the plastic. normally at the end i slice of any extra plastic or balsa to get it lite.

Next I used fevi bond on the rudder to glue the rudder to the plastic.sorry I tried video but could not manage  was difficult to shoot with phone in one hand and glue and this glue is very tacky so can't take video.
U can practice on a few scrap balsa sticks before doing this.

Press the rudder on the plastic well so that the glue catches it well.

The plastic is now cut as much as needed for the rudder and flattened on a  table and corner are stuck with paper tape.stick the plastic well nice and flat.

My wing,elevator and rudder covering is prepared

After 15mins peel of the plastic from the paper and there we have are wing covering.
Remove the paper throw it and let the plastic sit in the same water till it cools.
After it's cools remove the plastic and rub off all the extra glue from it under tap water.make sure no glue on it..put it under a light and check ,once all glue removed we can dry and use it.

WING COVERING:MATERIAL USED IS THE LAMINATE ON THE BROWN BOOK COVER.
PROCESS:take a vessel fill it half with water,crumple the brown paper and put in the water the paper side down and laminate side up.push the paper in the water.then put on the gas and let the water boil for 15mins.