Hi every,
I am Hindol, I am new to RC India Forum. after searching too many web sites, i found out that many people making RC planes either with foam or balsa sheet or thermocol etc. but i couldn't find out if there anyone try to make extra 300 3D plane with cor-flute/cor-plast. on you tube, i found out some one making RC plane with these kind of material, but not extra 300 3D / YAK 54 type of models.

 

these kind of material are used for making caution boards on mobile towers by Airtel, Reliance, Idea etc.
they are very light & and you can cut or shape these with a knife/Cesar knife or normal Cesar even with the regular blade also.
i am making a extra 300 3D type model, i finished it, but didn't tested yet. specification..........

1. around 17.5" length
2. 28" wing span
3. couldn't figure out wing area.
4. 3 no 9Gm servos
5. 1400 Kv Brush-less prop-saver out-runner Motor.
6. 20 Amp ESC
7. 7.4 volt 850mAh/ 7.4 volt 350mAh battery
8. GWS 8x6" Propeller

i didn't measure the weight of the plane, but actually my question is can we make cor-flute fly in the sky or 3D models can't be made out of these kind materials. i can upload the picture of my plane if you say so. if you can, plz help me....

http://www.spadtothebone.com/freeplans.htm
http://www.rcindia.org/gas-glow-nitro-planes/a-new-3d-spad/
http://www.rcindia.org/electric-planes/electric-spadstick-build/
http://www.rcindia.org/electric-planes/samurai-my-extra-300-spad/
http://www.rcindia.org/electric-planes/rcpowers-extra-300-using-3mm-coro/

Use search option of the forum, you might find some more.

Thanks my friend