hello guys i am posting yet another step by step guide to building your own vpp motor first lets see how to open up a motor.
The steps are to remove a small e shaped clip from the bottom of the motor attached to the shaft.
and then you will see a small gap between the drum and the base
next step is to pull the two apart
done you have a motor ready for shaft replacement
first image - showing the clip you need to remove
Opening a Bl motor and converting to VPP
second image - to remove the e-clip poke it out with a pen tip or a scissors one blade. it comes out easily
Opening a Bl motor and converting to VPP
Third image - showing the clip you just removed
Opening a Bl motor and converting to VPP
Fourth image - showing the gap evolved after removing the e-clip
Opening a Bl motor and converting to VPP
Fifth image - showing the two halves after being pulled out
Opening a Bl motor and converting to VPP
now before starting with the vpp installation sai uncle can you tell me how to remove shaft from the rotating drum. do i hammer it down actually i saw two black stopper kind of things have a look at this image.
Opening a Bl motor and converting to VPP
thanks for the help and will put the next steps next week after i receive my vpp setup