hello everyone
i purchased crius multiwii se v2.0 from quadkopters few days ago...
i uploaded 2.2 firmware and compile the code and its shows done compiling
when i upload the code and its shows
avrdude: stk500_getsync(): not in sync:resp=0x00 and also shows "done uploading"
and when i start GUI i saw all sensors are working properly ,all rx channels (roll,pitch,yaw and throttl) are working properly and shows its value nearly about 1500 and min throttl value was 1150
now problem is that my board is not arming....
what should i do??
thnx