Frankly I shouldn't be calling this a build thread as I could not capture the build process. This project has been stalled as I have been flashing the wrong Hex image in to the PIC16F84 MCU. This tester has been published in Elecktor electronics and the PCB layout / Hex code are freely available on their site.
Features:
a. Input volatage of 8-15v (3s Lipo friendly)
b. No of servo : 1
c. Interface Buttons: i. Mode(Sweep/position) ii. Up iii.Down. Center when no button pressed.
Build Difficulty Level : Medium (Needs PIC programmer/PCB fabrication know how)
MCU: PIC16f84
Project URL:
http://www.elektor.com/magazines/2006/july/rc-servo-tester-exerciser.58302.lynkx?tab=2Here is the tester in action
The tester is giving jitters on the extreme down end, which I need to debug (anyone having a CRO in BLR please help)
Some closeups (Taken with Canon 20D /Tamron 90mm f/2.8 1:1 Macro with DIY pop-up flash diffuser)