http://www.youtube.com/watch?v=DnTiwcZTOCA
Motor  : TowerPro 2408-21T.
Prop    : 7x4
Battery: 2200mah, 3 cell.
ESC     : 30Amp
			
			
			
				Nice..is it possible to run your buggy in a striaght line as possible...?
			
			
			
				Yes Sandeep, it can run in a straight line. Little difficult to control it on land..  :giggle:
This weekend i will test it & post the video.
Thanks
			
			
			
				Few pics.
			
			
			
				More pics
 :)
			
			
			
				Cage for the prop. 
Made of wooden embroidery frame which is easily available in market, not complete yet. I have to cover the side of the cage with wire mesh.
			
			
			
				Rudder.
Sorry for the poor video, recorded it from my mobile phone.
http://www.youtube.com/watch?v=rAUSKsY-3fY
			
			
			
				Masta build ahe  Sarad bhauu!!
			
			
			
				Inspirational Build, very impressive. {:)}
Paint Job is icing on the cake.
			
			
			
				Thanks Ujjwal & Akshay,
The model is not painted, i have done stickering job on it.
I had some vinyl sticker left with me, so decided to cut those stickers for this model.
			
			
			
				The stickering job is superb. For a sec i tot it was balsa with monokote :D where do you plan to test this ? :)
			
			
			
				Thanks Rajath,
Planning to test it in the lake near to Hoskote this weekend.
			
			
			
				FINALLY IN WATER.
Couldn't push the throttle more then 60% as the model was bouncing on the water & i had not sealed it properly.
http://www.youtube.com/watch?v=33bSpIENefk
http://www.youtube.com/watch?v=GQl7rt3dpKE
 :)
			
			
			
				Hey RC! That is a BEAUTIFUL build! I really like this one. :thumbsup:
Please share a few details about the building materials used. Is it balsa?
			
			
			
				Thanks VC.
I have used sunboard for this model.
Hull: 22 inch length, 10 inch width & 3 inch height.
			
			
			
				Awesome RC :) Where is this place ?
			
			
			
				Super RC. Where is this place?
			
			
			
				hi R C
the 'swamp buggy' goes really well, and looks very good............ ...good job there.
perhaps it could do with a little weight midships to help with the 'bouncing' at higher speed?
these do tend to be 'top heavy' with the motor on a pillar......perhaps put the motor down on the hull and 'belt or gear' drive to prop.
[a gear on the motor and the 'same size' gear for the prop would give the same out put as now]
regards
don
			
			
			
				Thanks all,
This place is just 2kms away from my house.
Thanks Don for the inputs, yes it was a  little weight midships, i will try to rectify it.
Thanks
 :)
			
			
			
				Not sure if your buggy looks better, or the location you are testing it !
:goodjob:
			
			
			
				All most missed this, very nice build. Love the video's  {:)} want to see it go faster :thumbsup:
			
			
			
				like this sarad