Hello,
I am a newbie at making RC airplanes, and while I am working on my first project, I couldn't really figure out as to how do I incorporate elevators, rudders and ailerons on my craft. For example, how do I create a hinge joint between the elevator and the horizontal stabilizer. I hope I was able to convey my problem.
I would be glad if anyone could help me out with this, as most you must already be knowing on how to go about it.
By the way, I am using Blue Form as the fabrication material, and length of the horizontal stabilizer is around 40 cm. (Just in case you need this information)
Thanks so much. You have a great weekend.
Regards.
Just visit this site.
http://www.rcgroups.com/forums/showthread.php?t=778306 (http://www.rcgroups.com/forums/showthread.php?t=778306) :thumbsup:
It would be better if we built up our own information content as much as possible :headscratch:
Hope these topics help !
http://www.rcindia.org/tools-materials-and-building-techniques/hinges-from-waste/
http://www.rcindia.org/tools-materials-and-building-techniques/how-to-connect-control-surfaces-with-hinges-using-caglue/
I am sure there are more, with a bit of searching here.