9Ch 2.4GhzTurnigy tx w/ Module & 8ch Rx (MODE 1) V2
MODE 1(THROTTLE ON RIGHT) V2
With v2 firmware update, correcting many flaws of the previous 9X, plus inbuilt 2.4Ghz (no daggy second antenna) this is a quality, reliable 2.4Ghz system suitable for beginners and pro pilots alike.
Get that locked-in feeling that only 2.4Ghz glitch free technology can provide.
Ultra fast reaction times and interference free control of your model is only achievable with this 2.4Ghz technology.
Without a doubt, the best value 9Ch system available!
Number of Channnel: 8ch ppm/9ch pcm
Display: 128*64LCD
Support Type: Heli/Acro/Glid
Support user: 8
Stick model: 4
Encoder type: ppm/pcm
Subtrim: Yes
Simulator Interface: Yes
Buzzer: Yes
Low Voltage Show: Yes
Required:Battery
Included:Turnigy 9x 9Ch Transmitter
Turnigy RF9X-V2 module
Turnigy 9X8C-V2 8-channel receiver
Binding your Tx to Rx :
1. Connect 8 AA batteries inside your transmitter and leave it turned OFF.
2. Connect your Motor to your ESC.
3. Connect your ESC to your Receiver on Channel 3.
4. Connect your Bind-Plug to the BAT channel.
5. If you want to test a Servo, connect a Servo to Channel 1,2, or 4.
6. Connect any good charged Battery to your ESC. You should hear a beep from your ESC (some ESC's do not beep) and your Receiver's LED Light should start blinking. The LED is hidden under the sticker.
7. While Holding down the Bind-Range-Test Button, turn on your Transmitter. After about 3 or 10 seconds the LED will stop blinking and you should be able to control your motor and any extra servos you connected.
Binding is a special functionality of 2.4ghz systems ,which enables glitch free communication as the receiver accepts signals originating from Binded Transmitter.
Asking Price is 9000 + Shipping
Print
