what went wrong ???
the charge in the battery was completely off , i did not recharge or unplug the battery from the tx :headscratch:
whats wrong here :-\
1.not unplugging the battery from the tx 8-)
2.not re charging the battery 8-)
its a fly sky 9ch :banghead:
[Moderator's Edit] Chain posting is not allowed. The duplicate thread has been merged with this one.
Not recharging the battery ...
Even if you don't unplug the battery from TX..it does not damage the TX...as only overvoltage fries electronics not undervoltage
What kind of battery? It is impossible to answer your question without knowing.
Yes. What battery is it?. If nicd it can be recharged again. But if lipo . its probably dead by now. Change the battery pack and check. Make sure u put the polarity right or u will fry or tx board.
yes thats what i thought but one of my friend compared it with a dslr camera scenario, that we take off the battery once the charge is up. :headscratch:
its a lipo 12V .. and the tx has a direct charge in pin..
Direct charge in pin is supposed for NiCd and NiMh batteries and not Lipo ..because Lipo need a special charging algorithm and balancing.
sorry no exact info on the battery ... so just thought of it , so can i make the battery work.. if yes how?
That makes no sense. You just thought of what?
An apparently dead LiPo can be recovered with slight damage to the cells.
firstly it dosent have any thing written on it so i thought it is might be a lipo , but as i mentioned tx has a direct charge pin so now it make sense it should be NiCd or NiMh ..... { sorry i was confused }
my only doubt now is can a NiCd or NiMh leak out and damage the Tx???