|
Title: how to rebind flysky 6ch 2.4Ghz receiver? Post by: akash chitmitwar on February 04, 2013, 09:59:31 PM how to rebind flysky 6ch 2.4Ghz receiver?
Title: Re: how to rebind flysky 6ch 2.4Ghz receiver? Post by: arun.sreelakam on February 04, 2013, 10:05:48 PM 1. switch off the transmitter
2. plug the bind plug into battery port of reciever 3. power the receiver through any other port 4. Press and hold the bind button in transmitter and swith it on 5. The receiver light will stop blinking... 6. disconnect battery from receiver, remove the bind plug. 7. swith off the transmitter now its binded.. always switch the transmitter on before powering up the receiver.. :thumbsup: :thumbsup: :thumbsup: Title: Re: how to rebind flysky 6ch 2.4Ghz receiver? Post by: rastsaurabh on February 04, 2013, 10:09:21 PM Follow these steps....
put bind plug in the Rx put power to rx ...see vcc written red light on RX will start blinking Switch on the TX holding the bind button on TX... notice the red led it will stop blinking.... meaning binding done. switch off TX remove Bind plug change power to CH3 ON TX then power on RX ..... you should see response on servo |