|
Title: How to remove Ball bearing from Ace C1016 servo main gear Post by: gauravag on January 15, 2010, 05:50:47 PM Hi,
I was trying to change the gear on my Ace C1016 servo, but there is a ball bearing on the main gear which i need to take out and put it on the new gear. I cannot just get this out . I even tried heating the gear a little bit, but it didnt help. Any ideas ? -Gaurav Title: Re: How to remove Ball bearing from Ace C1016 servo main gear Post by: anwar on January 15, 2010, 10:32:24 PM Some options.
1. Use a bench vise to hold the bearing along, and tap out the gear. I had to do this once with some, from what I can recall. If you do not have a bench wise, improvise ;) 2 bricks and 2 steel rules stategically inserted under the bearing on both sides is one I can imagine. 2. Use a dremel to drill out the old gear. This can also be done manually, if you have the right tools. Since you are going to discard the old gears anyway, this should not be an issue (assuming I understand correctly what you are trying to do). |